Quote:
Originally Posted by Brian Bines
Hi Troy,
The three pieces of Luftwaffe parachute relics I have are all yellow and from 1944, I was told that when the canopy material changed during the war the yellow was added as a preservative dye.
I believe the Luftwaffe paratroopers operated on a canopy first principle where the canopy started to deploy as soon as the static line extended. Allied paratroopers canopies deployed following the static line pulling off the containment bag once the shroud lines were extended i.e. canopy last,
Regards
Brian Bines
P.S. have just checked the two Luftwaffe aircrew Backchutes I have (no canopies) both have four shroud rings, two per side each pair coming off of a short length of single strap ( are these single straps the risers ?). Hope this helps like Jon I am no expert.
|
Hi Brian
This is awesome! Can you tell me what shade of yellow??
I know most people on this board could care less but I have spent most of my adult life in the parachute industry. So for everyone out there that wants to know, here are the correct terms for refering to the various parts of a parachute starting from the top:
Pilot chute: A small parachute which in emergency parachutes is spring loaded and acts as an "sky anchor" when deployed allowing the rest of the parachute to deploy in an orderly manner.
Canopy: This is the big umbrella that saves your life. American pilot emergency canopies are either 28' 26' or 24' in diameter. There is always an apex vent at the top to allow air to escape otherwise the canopy wolud oscillate severely.
Suspension lines: These are the lines that attach the canopy to the risers. There are as many lines as the diameter, 24, 26 or 28. and are aproximately as long as the diameter.
Connector links: These are metal fittings that are attached to the risers to which the suspension lines are attached.
Risers: There are 4 in American parachutes, two front and two rear to which four equal amounts of suspension lines attach to. In emergency parachutes the risers are actually part of the harness either made of the same length of webbing or sitichted into the harness so as not to separate during a hard opening shock.
Harness: This is the webbing that makes up the secure saddle in which a parachutist is supported. The harness consists of the main lift web which is the vertical harness strap on the left and right of the torso these generally go over the shoulders and cross the back going down to form the leg straps. There is a chest strap connecting the right and left main lift webs as well as lateral straps in the kidney area connecting the main lift web to the harness after it crosses the back.
Container: The container is usually made up of a tray to which the canopy, suspension lines and risers are stowed into and four flaps of fabric like cotton duck that fold up to secure the parachute inside. There are grommets and cones that hold the container closed
Ripcord: this consists of two parts, the handle and the cable. At the end of the cable are pins that secure the container shut. The ripcord cable passes through a metal housing that is tacked down to the harness and container.
This entire assembly is referred to as a parachute rig or just a rig.
When the parachutist pulls the rip cord to arms length the pins are also pulled clear of the grommets and cones allowing the spring loaded pilot chute to launch and start the deployment sequence.
Note: there are no "D Rings" on pilot emergency rigs. "D Rings" are attached to the main lift webs of paratrooper rigs or to the harnesses worn by bomber crewmen. it is to these rings that the "Quick Attachable Chest Parachutes" clip on. So when you hear someone say he pulled on his "D-Ring" what he really means is that he was pulling on his ripcord.
Well I hope y'all enjoyed what I have written.
Cheers
Troy