![]() |
|
Allied and Soviet Air Forces Please use this forum to discuss the Air Forces of the Western Allies and the Soviet Union. |
![]() |
|
Thread Tools | Display Modes |
#31
|
||||
|
||||
Re: About WW2 fighter aircraft firing power
Hello Tony
thanks for the correct link. How embarrassing! I googled to Emmanuel’s site by typing “WWII Gun power” and seeing the book covers assumed that it was yours. I even looked vainly for analyze of ammo effectiveness which I remembered to be somewhere in your site but of course didn’t find it. Then I concluded that you have removed it. Really embarrassing. But you cleared my mistake and so Rob got the info. Juha |
#32
|
|||
|
|||
Re: About WW2 fighter aircraft firing power
Quote:
Things get very complicated when increasing number of factors are accounted; I have not even touch the factors like rate of fire, lenght of the burst and density of projectiles in the target area (dispersion in other words). I have seen probably similar analysis as mentioned by Peter Verney above; as example RAE did analysis on gun camera films (real combat footage from RAF, USAF and GAF and simulated attacks) and studied many factors like aim wander and error, lenght of the burst etc. were measured and analysed. I think you have couple possibilities here. The easy way is to stay strictly on easily measurable factors like rate of fire, muzzle velocity and energy content and in the end you have probably very similar results as Tony got. The hard way is to try to understand how these more or less random factors like aim wander and error, dispersion, burst lenght etc. affect on different guns. |
#33
|
|||
|
|||
Re: About WW2 fighter aircraft firing power
Quote:
There is obviously differences how the Air Forces saw the benefits of the guns. The MG 151 is a good example because USAF did seriously consider to use it (15mm version) while the Germans went towards larger calibers. In the Russia 20mm ShVAK was older weapon and, at least according to Finnish experience, less problematic than the Berezin. |
#34
|
|||
|
|||
Re: About WW2 fighter aircraft firing power
Thanks, Harri. In his analysis Tony Williams included factors such as the benefits of mass production of a single weapon type rather than a multitude, and most of all the fact that the US considered their .50 to be, perhaps not the most efficient gun, but a combat proven and adequate one. Benefits of a different nature than can be expressed with gun & ammo technicalities only.
Regarding the complexities of a hitting capability definition: let's go the hard way, and see where we end. If the matter was easy, and with that most likely well known, then I would not have raised it. I agree that equasions with rate of fire, muzzle velocity and energy content shall lead to conclusions that were already nicely summarized by Tony. I do not agree with his proposed calculation of explosive energies, that rather simplifies the matter, but would agree that a more elaborate calculation would probably lead to the same or similar results in a table with comparative data. In any case, I'm not finding pattern density, or dispersion, anywhere in these considerations. It strikes me that this could be a flaw, that is not present in the world of hunting shell ballistics. Note that "dispersion" has a negative ring to it, as in "deviation from the perfect line". That would be valid at the target practice range, but it might be a desirable feature in aerial combat. I once witnessed so-called accidental automatic fire coming out of an AR 15 rifle. Obviously the interruptor was modified to produce automatic fire from this civil version of the M16. Three rounds, and all three in a group of 3 cm diameter at a 100 meter range, and on top of that all within the inner circle of the bullseye of the 100 m target. First class accuracy, that would however be pointless in actual combat, where one of these hits would have been quite enough to incapacitate the opponent. This splendid accuracy does not increase the chances of hitting, it merely wastes ammo at the same point of a basically motionless target. The pattern is too dense to make sense under these conditions. In aerial combat things would be different, as the target is moving fast, in four dimensions. Multiple hits at the same spot with non-explosive rounds could accumulate the damage done. If not at the same spot, which is very unlikely anyway at regular firing ranges, then multiple hits close together could lead to a greater net effect than can be calculated as the sum of the effects of all hits. A wing spar may not yield after a hole has been shot into it. It may not yield after several holes. But it may yield if several holes are shot close together. This is another way of saying that, if we forget about explosives for the moment, pattern density is a factor that needs to be considered. And surely, as stated by Tony in his post of today, this makes sense only if the individual rounds can do damage at all. Pattern density is presented here as a factor in damage infliction. It is also a factor in my key interest: hitting capability. Perhaps it would be better to speak of "pattern spread" here. The larger the pattern, the easier it is to score hits on a target of a given size on a given distance. The pattern cannot be enlarged beyond the point where the projectile density becomes too low to score hits, and/or to be effective in inflicting damage. There must be an optimum here. My question is: how can we define that optimum? Leaving out explosive rounds, then this optimum is likely to be a trade-off between number of rounds per second, their damage inflicting properties, and their dispersion in a plane vertical to the line of fire. Regards, Rob |
#35
|
|||
|
|||
Re: About WW2 fighter aircraft firing power
Quote:
I have analysed the US reliance on the .50 here: http://www.quarry.nildram.co.uk/CannonMGs.htm |
#36
|
|||
|
|||
Re: About WW2 fighter aircraft firing power
Quote:
Quote:
The harmonisation arrangements are also affectd by the destructiveness of each hit: the less powerful your ammo, the more important it is to concentrate its fire to achieve acceptable effectiveness. So the RAF had to reduce the harmonisation distance - in other words, tighten the pattern - for its 8x .303 fighters during the BoB, but considered increasing the dispersion of Hispano armament, because only a few hits were needed for a kill. Quote:
There was only one way to ensure a close grouping of hits - and that was to get very, very close before opening fire. And by that I mean 50 metres or less. Not many pilots were capable of that. |
#37
|
|||
|
|||
Re: About WW2 fighter aircraft firing power
Thanks, Tony. I had read the statements from Henning Ruch. I believe that your suppositions made to make the matter manageable, underestimate the power that is delivered by explosives. However, as said, if these, or other, suppositions are applied consistently to all gun/ammo systems in a comparison, then results are likely to be comparable, and perhaps even quite similar. I cannot prove this as I cannot point to objective measurements of explosive force. The cavity size blasted in gelatin would be an objective measurement, if this would be a practicable technique.
"Pattern density is partly a function of the harmonisation arrangements, but equally so a function of the combined rates of fire of the armament." Exactly. And added to that factors such as gun platform vibration under firing, delivering a dispersion that did not result from design, but that could nevertheless be used in a weapons system design. Density required shall be controlled by the projectiles employed, as in your .303 machine gun vs. 20mm cannon comparison. Now we are heading towards clarity about desirable pattern densities. This cannot be studied by looking at individual guns and/or ammo's. The entire aircraft with multiple gun and/or cannon and ammo needs to be considered as a system. Or ammo's, plural, if more than one type is to be deployed. The last is what you did, calculating for a repetitive 3 HE + 1 AP ammo arrangement in the belt. Pattern density shall be maximal at the point where projectile trajectories converge. Before and after that the pattern shall be basically conical in the direction of projectile flight. Harmonisation seems to have been done according to this one-point-convergence strategy, that point being about 300 to 200 yards out, as the fashion of the day had it. Are you aware of other arrangements that may have been used? Meaning harmonisation to parallel trajectories, or perhaps to a circular pattern at the envisaged engagement range? One other point that you raised in the articles. The presence of tracer is mentioned as undesirable, as it reduces space that could otherwise be filled with HE, and as tracer gave away the fact that somebody was shooting at you. On the other hand, wasn't tracer an excellent aid in deflection shooting, as the pilot could see where the rounds were going, enabling him to let the opponent fly into the pattern, or to chase the pattern into the opponent? Regards, Rob |
#38
|
|||
|
|||
Re: About WW2 fighter aircraft firing power
ISTR that harmonisation of our Mosquitos in 1952 was two guns at 350 yards and two at 250 yards. Giving an idealised firing range of 300 yards. Of course in practise, firing at drogues and at ground targets, there was only time for a quick squirt at about 350 yards with the range rapidly decreasing. Bear in mind that firing on the target was not permitted at less than 30 degrees angle off for fear of ricochets hitting the tug.
When we switched to the Meteor NF with wing mounted guns I think similar harmonisation applied. Incidentally I do remember an incident when a wing commander, eager to get a better score, closed to a lower angle off and bounced a shell clean into one of the tugs engines. Ball ammo of course, but made a horrible mess of the engine and as we only had one aircraft modded to tow a flag that put an end to the fun. In any instance scores were not marvellous and it was not unknown for a pilot to score a blank while over 15% on air to air was considered reasonable and over 30 very good.
__________________
Peter Verney ex nav/rad |
#39
|
|||
|
|||
Re: About WW2 fighter aircraft firing power
Thanks, Peter, a most vivid picture of the difficulties encountered in practice. Two point harmonisation added to the list.
Regards, Rob |
#40
|
|||
|
|||
Re: About WW2 fighter aircraft firing power
Two-point harmonisation was also used by some US fighters. I have a diagram of a P-47's harmonisation which is exactly the same as Peter described - 250 and 350 yards. I have also read that some pilots set each pair of .50s to converge at a different range. This meant that they never had really concentrated fire at any range, but moderate concentration at all ranges.
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Friendly fire WWII | Brian | Allied and Soviet Air Forces | 803 | 8th July 2023 15:47 |
Book on French AF 1939-40? | The_Catman | Allied and Soviet Air Forces | 68 | 10th August 2008 15:58 |
Airpower summary | Pilot | Post-WW2 Military and Naval Aviation | 0 | 23rd February 2007 15:11 |
Aircraft performance curves | Christer Bergström | Luftwaffe and Axis Air Forces | 17 | 19th November 2005 21:49 |
Fighter pilots' guts | Hawk-Eye | Allied and Soviet Air Forces | 44 | 8th April 2005 14:25 |